HOME>Products>Back

Sensor Interface – High Temperatures Model：Sensor Interface – High Temperatures

This sensor interface is intended for temporarily connecting bare Kapton-or Teflon-insulated Hot Disk or Hot Strip sensors to sensor wires, and to accommodate measurements at high temperatures, up to 300°C.

Add to Inquiry

Detail information Specification

The sensor interface consists of an aluminum and PEEK polymer housing with a slot for sliding in the sensor. A pressure connection between the sensor contacts and the sensor wire ends is made by torque screws on the back side of the housing. The four sensor wires are insulated with a high temperature hosing capable of beyond 300°C ambient temperature, and at their other end they are connected to our grey-colored polymer-clad sensor cable. Note that the latter can only handle 50°C, wherefore if this sensor interface is to be used in a temperature chamber, the wires with high temperature hosing need to be fed through and extend outside the temperature chamber.

The length of the sensor wires with high-temperature hosing are by default 1.5 m long but can be made shorter or longer upon request.

Sensor Interface

Housing material	Aluminum and PEEK polymer
Temperature range	Up to 300°C
Cable length
High temperature hosing	1.5 m (shorter or longer on request)
Polymer-clad	2.0 m
Cable connector	8-pin Lemo (male)