HOME>Products>Back

Sensor Cable – Low to Medium Temperatures Model：Sensor Cable – Low to Medium Temperatures

This red-colored silicone-clad sensor cable is intended for measurements at low to medium temperatures, down to -60°C and up to up to 180°C, with our Kapton- or Teflon-insulated Hot Disk®, Hot Strip®, or Hot Cell® sensors. The cable comes with a 4-pin Lemo connector in one end and with four bare wires in the other end for permanent connection to the sensor.

Add to Inquiry

Detail information Specification

The sensor connection is achieved by soldering, which in turn is protected by an aluminum housing (or silicone pads). For connection to our Hot Disk® instruments (or our sensor switch units), our grey-colored adaptor cable is needed, which is offered separately. It converts the 4-pin Lemo connector into the 8-pin Lemo connector for our instruments (and switch units).

When ordering our Hot Disk® and Hot Strip® sensors with this cable they come connected by default, with aluminum housing (or silicone pads on request). However, spare sensor cables as well as spare aluminum housings can also be ordered.

Sensor Cable

Cladding material	Silicone
Housing material	Aluminum
Temperature range	-60°C to 180°C
Cable length	1.0 m
Cable connector	4-pin Lemo (male)